Choose another country or region to see content specific to your location.

Prodigy: the thread-through meter without terminal block

Once I showed a meter to Sanjay Saab in our AECo (Ahmedabad Electricity Co Ltd – presently Torrent Power) meter laboratory which was in a cast iron box and had three wires with soldered lugs projecting out on both sides. It was a two element three-phase three-wire 400 volt 200 amp meter, with a built-in bar type current transformer (CT), with a CT-secondary, directly connected to the meter. I do not have a photo of this meter but to get a feel of it, I have shown a photoshop constructed replica here.

Sanjay Saab loved this idea. Immediately he started narrating the advantages of such a 200 amp meter:

  • Easy installation
  • No wrong phase association
  • No CT reversal
  • Tamper resistance
  • Low burden on CT secondary wires
  • Meter is calibrated along with CT, hence meter error includes CT error, with lowest total error
  • Compact installation

After a well thought out product development, which went through many design changes and overcame various issues, eventually a meter (Prodigy) was developed with four CTs

On another visit, he asked me to show him the meter again. I am sure that all the time he had been thinking of having a direct 200-ampere meter. We discussed the possible methods of avoiding the cable and lugs and about making through holes, to pass an insulated conductor through the meter box and the CT. But since the meter needs potential, how was it going to be possible to tap the potential in the meter box on an insulated conductor after its insertion through the CT?

On a subsequent visit, he came up with the idea of a piercing clamp, which would avoid peeling off the conductor insulation and make the associated potential available to the meter.

After a well thought out product development, which went through many design changes and overcame various issues, eventually, a meter (Prodigy) was developed with four CTs, since by this time every meter engineer was convinced that a three-phase three-wire (two-element) meter has many disadvantages.

Sanjay saab loved this idea

The final version was tested in a live condition under a polluted water shower until it passed the test.

Prodigy was designed for outdoor installation without any meter box or rain sheds. It was thoroughly tested under a water shower in the laboratory and passed all the tests.

For on-site testing, a few samples were installed in the field and after the first rain showers, all of them were returned as a lump of plastic and metal. We learned that this was because pollution, together with moisture, had created problems.

Again the design underwent a change to create creepage (breaking the water path). The final version was tested in a live condition under a polluted water shower until it passed the test. Polluted water was created in the laboratory by mixing water with sea salt and dry carbon dust collected whilst cleaning the silencers of vehicles from Pratapnagar choraha (crossroads close to our head office).

Prodigy was developed as an outdoor meter with all the latest features for tamper detection, remote reading and communication

In one state, the Power Minister who was aware of the mischief played out with CTs and meter wiring would say, “I want a meter without chuddy [ring CT].” – i.e. Prodigy.

Prodigy was developed as an outdoor meter with all the latest features for tamper detection, remote reading and communication. Many utilities have mounted Prodigy on a pole at the factory gate to avoid fiddling by consumers.

-G K Panchal