The Receiver is a member of the stylish and intelligent Beanbag family of home heating control products, designed to ensure your comfort at all times, while minimising energy consumption.  

Beanbag products can be used together in many different ways, and can be integrated with other home control equipment to suit a wide range of heating systems. The Receiver is the ideal partner for the Thermostat and Gateway, all working together through interoperable low-power radio communications. A smartphone app enables you to read the temperature, receive alarms and adjust the set point from anywhere with an Internet connection. You no longer have to worry about returning to a cold house.

The Receiver is a two-channel unit and is ideal for replacing traditional wired controls for systems that require separate control of heating and hot water. It comes with its own wall plate, and includes load compensation software that significantly improves boiler efficiency by preventing short-cycling and overshooting of temperature in the heated environment. Load compensation controllers have been shown to save energy compared to traditional systems, while maintaining more consistent comfort levels.



    • Heating control as part of a Beanbag smart home system
    • Domestic gas or oil-fired central heating and hot water systems
    • Boiler and hot water control, with local override via buttons on fascia    
    • New and retrofit systems
    • Specification
    • Electrical

      Number of channels


      Relay input voltage rating (CH1 and CH2)

      12 V to 30 V DC, or 230/240 V AC (50 Hz)

      Relay input/output current rating

      3A resistive /1A reactive


      230 V/240 V AC (50Hz)

      Insulation category

      CAT II

      Software class

      Class A

      Control type




      Z-Wave Plus compliant

      Operating frequency

      868.42 MHz (EU)

      Receiver Category

      Category 3

      Power Class

      Class B

      RF range

      >100 m, line of sight



      125 mm x 112 mm x 35 mm


      161 g (approx.)

      Case material

      Thermoplastic, flame retardant


      Wall plate, with optional fascia plate (supplied)

      Mounting mechanism

      Push ON, pull OFF

      Cable access

      Centre or top/bottom/left/right, using surface wire plate


      Impulse voltage rating

      Cat II 2500V

      Enclosure protection


      Pollution degree

      Degree 2

      Operating temperature range

      0˚C to +40˚C

      Storage temperature

      -20°C  to +70°C

      Environmental humidity range

      0 to 90%


      Design standards

      Product standard: EN 60703-1, EN 60730-2-7

      R&TTE :

      Radio: ETSI EN 300 220-1, ETSI EN 300 220-2

      EMC: ETSI EN 301 489-1, ETSI EN 301 489-3